Natural wood console table is important free furniture that adds a lot of aesthetically appealing to your modern living room. While the process may seem extremely difficult, it is actually quite simple if you follow proper instructions
Take four 28 “pieces of 2×4 wood and cut piece of MDF wood into a 15” X48 “piece with a circular saw. Marks should be made to a 2 1/2 “and 3 3/4” in from that point too. Drill holes on all these points. Stand the natural wood console table top so that the driver’s holes are facing you at the same time about an additional piece of MDF on the floor next to it. Take an extra piece of 2×4 “wood and place it evenly with the table top and piece MDF. This piece of wood gives an exact measurement of where your leg will go. Secure two screw holes to secure the first leg to the table top. Continue until all four the legs have been stuck.
Slide one of the 10 1/8” pieces into one of the shorter sides of the natural wood console table between two of the legs. Repeat this step for the other side of the table. Place a 41 3/4 “piece of wood between the two pieces of wood you are attached. Drill two holes on both sides and screw them into the table. Repeat this step for all commands. Add a layer of bite or color as desired.